Home › Guides › Essential loads and load shedding

Essential loads board and load shedding

Why use an essential-loads board, choosing essential loads, how it is wired, changeover options, load shedding by hand, automatic load control, off-grid systems, and example setups.

By Michael Johnson · Updated 18 November 2026 · How we check our guides

Few home batteries or generators can run an entire house. The practical answer is to decide which circuits really matter in a power cut (the fridge, freezer, boiler pump, lights, router and medical equipment) and feed only those from the backup supply. That's an essential-loads board, sometimes called a critical loads or backup circuit board. Alongside it, load shedding means switching off or automatically dropping big loads so the battery or generator isn't overloaded. This guide covers choosing essential loads, how an essential-loads board is wired, automatic changeover, load shedding by hand and automatically, priorities, and practical examples.

This is fixed wiring work. Splitting a consumer unit, fitting a changeover or connecting a battery or generator to a house must be done by a qualified electrician, following the wiring regulations and notifying building control where required. Never back-feed a house through a socket.

1. Why use an essential-loads board?

2. Choosing essential loads

Usually essentialSometimesUsually not
Fridge and freezerA few sockets for laptops and phonesElectric shower
Gas or oil boiler and pumpsMicrowaveOven and hob
Some lighting circuitsWell or water pumpImmersion heater
Router and phoneSump pumpTumble dryer
Medical equipmentSecurity systemEV charger and heat pump (without a large system)

Add up the power and daily energy of the loads you choose with the home backup battery calculator and the appliance wattage chart.

3. How it's wired

4. Changeover options

OptionHow it worksBest for
Manual changeover switchYou switch the essential board from grid to generatorGenerator backup
Automatic transfer switchSwitches automatically when the grid failsStandby generators
Inverter-charger or hybrid inverter "backup" outputGrid passes through; inverter takes over in millisecondsBattery backup systems

See the transfer switch guide and the inverter-charger guide.

5. Load shedding

6. Automatic load control

7. Off-grid systems

8. Example setups

HomeBackupEssential loads
Typical UK semi with gas boiler5 kWh battery, 3 kW inverterFridge-freezer, boiler, router, lighting, a few sockets
Rural home with well10 kWh battery or generatorAs above, plus water pump
Home with oxygen concentratorBattery with fast changeoverConcentrator circuit, phone, lighting

See the home backup power guide and the grid-tied solar and battery guide.

9. Frequently asked questions

What is an essential-loads board?

A separate consumer unit holding the circuits you want powered in a power cut, fed by a battery inverter or generator.

What should go on a backup circuit?

Typically the fridge, freezer, boiler and pumps, some lights, the router and any medical equipment; not showers, ovens or immersion heaters.

What is load shedding?

Switching off or automatically dropping less important loads so the backup supply isn't overloaded or drained.

10. Sources

  1. Victron Energy community, enabling Multi AC output 2 during grid outage: victronenergy.com
  2. Victron Energy, MultiPlus-II inverter/charger datasheet: victronenergy.com
  3. U.S. Department of Energy, planning a home solar electric system: energy.gov

New to some of the terms? See the glossary. Not sure where to start? Try start here.