Home › Guides › Storage heaters in power cuts

Storage heaters in a power cut

How storage heaters work, what happens in a power cut, making stored heat last, preparing for storms and cold snaps, teleswitch meter problems, heat batteries and alternatives, backup heating, and safety.

By Michael Johnson · Updated 18 November 2026 · How we check our guides

Many UK homes, especially flats and homes off the gas grid, are heated by electric storage heaters. They charge up overnight on cheap off-peak electricity and release the heat during the day. That design has a useful side-effect in a power cut: a fully charged storage heater keeps giving out warmth for hours after the power goes off, unlike a gas boiler, which stops instantly. But if the cut happens overnight while they're charging, or the meter switching fails, you can wake to cold heaters. This guide explains how storage heaters behave in power cuts, how to make the most of stored heat, heat batteries and modern alternatives, the end of teleswitch meters, and backup heating.

In a power cut: turn the output (or "room temperature") control down to keep heat in the heater for longer, close doors and curtains, and live in one room. A well-charged heater can give useful warmth for much of the day.

1. How storage heaters work

Inside a storage heater are heavy ceramic or clay bricks surrounded by insulation. Electric elements heat the bricks overnight on an off-peak tariff such as Economy 7. During the day, heat escapes through the casing and, when you open the damper or turn up the output, faster through vents (some have a fan).

2. What happens in a power cut

When the cut happensWhat you'll notice
During the day, after a full overnight chargeHeaters keep giving out heat; older ones cool over the day, newer ones last longer
Overnight, during chargingHeaters only partly charged, or cold by morning
Long cut, over a dayHeat runs out; no recharge until power returns

3. Making stored heat last

  1. Turn the output to its lowest setting, and open it up only when you're in the room and need warmth.
  2. Choose one warm room with a well-charged heater, and keep its door closed.
  3. Close curtains and blinds, especially at dusk; draught-proof doors with a rolled towel. See the draught-proofing guide.
  4. Close doors to rooms you aren't using, and keep their heaters' outputs closed.
  5. Don't cover or hang washing on heaters.
  6. Layer up and use hot water bottles and blankets. See the low-power heating guide and keeping warm in a power cut.

4. Before a forecast storm or cold snap

5. Teleswitch meters and timing problems

Many storage heaters were switched by "radio teleswitch" (RTS) meters, which received a long wave radio signal telling them when off-peak started. The RTS service has now been switched off, with the phase-out completed in June 2026. If your home still has an RTS meter:

See the prepayment and smart meters guide.

6. Heat batteries and modern alternatives

7. Backup heating

8. Safety

9. Frequently asked questions

Do storage heaters work in a power cut?

They keep releasing the heat they've already stored, often for much of the day, but can't recharge until the power returns.

How do I keep heat in my storage heater longer?

Turn the output to its lowest setting, open it only when you need heat, and keep doors and curtains closed.

What should I do if I still have a radio teleswitch meter?

Contact your supplier to replace it. The RTS signal has been switched off, so heating and hot water may not come on at the right times.

10. Sources

  1. Citizens Advice, using storage heaters and immersion heaters: citizensadvice.org.uk
  2. Home Energy Scotland, how to save energy with electric storage heaters: homeenergyscotland.org
  3. Octopus Energy, the Radio Teleswitch Service has come to an end: octopus.energy
  4. Which?, storage heaters: which.co.uk

New to some of the terms? See the glossary. Not sure where to start? Try start here.