Off-grid hot water: the options compared
How much energy hot water takes, gas, solar diverter, solar thermal, wood burner, diesel and calorifier options compared, vans and boats, Legionella and scalding rules, unvented cylinders, and ways to use less hot water.
By Michael Johnson · Updated 17 November 2026 · How we check our guides
Hot water is one of the biggest energy users in any home, and off-grid it needs a plan. The options range from a gas water heater or diesel heater to a solar thermal panel, a wood burner back boiler, or turning spare solar electricity into hot water with a diverter. This guide compares the options for cabins, vans, boats and homes, explains how much energy hot water takes, and covers the safety rules for Legionella, scalding and unvented cylinders.
1. How much energy does hot water take?
| Use | Hot water | Energy (from 10 °C) |
|---|---|---|
| Short shower (5 min, low-flow) | About 30 L at 40 °C | About 1 kWh |
| Bath | About 80 L at 40 °C | About 2.8 kWh |
| Washing up by hand | About 8–10 L at 50 °C | About 0.4 kWh |
| Typical person per day (UK) | About 40–50 L at 60 °C | 2.3–2.9 kWh |
That's more than many off-grid homes use for everything else, which is why heating water directly from batteries rarely makes sense, but heating it with surplus solar does.
2. The options compared
| Option | Best for | Pros | Cons |
|---|---|---|---|
| Gas instantaneous (tankless) heater | Cabins, vans, homes | Endless hot water, small, no tank losses | Needs gas supply, flue and minimum water pressure; must be room-sealed or outdoor type |
| Solar PV diverter to immersion | Homes and cabins with spare solar | Uses surplus that would be wasted; cheap to add | Little in winter |
| Solar thermal panel | Homes and cabins | More heat per square metre than PV | Plumbing, freeze protection, overheating in summer |
| Wood burner back boiler | Homes heated by wood | Hot water from heating you already need | Needs careful design and a heat leak |
| Diesel heater with water circuit (e.g. combi units) | Vans and boats | Heating and hot water together | Fuel use, noise, servicing |
| Engine calorifier | Boats and vans | Free hot water while the engine runs | Only when the engine runs |
| Heat pump water heater | Homes with good power | 3× less electricity than an immersion | Higher cost; needs reliable supply |
3. Solar diverters and immersion heaters
- A diverter (for example iBoost, Eddi and similar for grid-tied; dump-load controllers for off-grid) sends surplus solar power into the immersion heater instead of exporting it or wasting it.
- Off-grid: when the battery is full, the charge controller would normally throttle the panels. A diverter or the inverter's programmable relay can switch on a water heater element to use that surplus.
- Low-voltage DC immersion elements (12/24/48 V, 300–600 W) can be fed directly from a solar array or battery surplus.
- Keep a backup (gas, wood or a timed boost) to reach 60 °C regularly in winter.
- See the grid-tied solar and battery guide.
4. Solar thermal panels
- Flat-plate or evacuated-tube collectors heat a fluid that warms a twin-coil cylinder.
- In the UK they typically provide 40–60% of a home's annual hot water, more in summer; in Australia and the southern US much more.
- Need freeze protection (glycol), a pump (which can be solar-powered), an expansion vessel and protection against overheating.
- Thermosiphon systems (tank above the collector) need no pump and are common in Australia.
5. Wood burner back boilers and thermal stores
- A back boiler on a wood stove heats water as you heat the room. It must have a heat leak (a radiator or gravity circuit that always works without power) so it can't boil if the pump stops.
- A thermal store (a large insulated tank) can take heat from several sources: wood, solar thermal, PV surplus, gas.
- Back boilers must be installed by a competent installer: HETAS in the UK. See the wood burner guide.
6. Vans, boats and calorifiers
- A calorifier is a small insulated tank (15–75 L) with a coil heated by the engine coolant, plus a 230 V (or 120 V) immersion and sometimes a coil for a diesel heater.
- Run the immersion from shore power or an inverter only with ample battery and solar; a 1 kW immersion heating 20 L uses about 1 kWh.
- Gas instantaneous heaters for vans must be room-sealed and approved for vehicles.
- Drain or protect water systems from frost in winter.
7. Legionella, scalding and pressure safety
- Legionella: HSE guidance (UK) is to store hot water at 60 °C or more and distribute it at 50 °C or more (55 °C in healthcare). Bacteria grow between about 20 °C and 45 °C. A solar-only or low-temperature system should be boosted to 60 °C regularly.
- Scalding: fit a thermostatic mixing valve so taps deliver no more than about 48–50 °C, especially for children and older people. In the UK new baths must be limited to 48 °C; in Australia new installations are limited to 50 °C at outlets in bathrooms.
- Unvented cylinders (mains-pressure, stored above 15 L) in England and Wales fall under Building Regulations Part G3 and must be fitted by a qualified installer, with a pressure and temperature relief valve and a tundish.
- Every pressurised cylinder needs a working temperature and pressure relief valve.
- Gas water heaters must be fitted by a Gas Safe engineer (UK) or licensed gas fitter, with a CO alarm nearby.
8. Using less hot water
- Low-flow shower heads (6–8 L/min) halve the energy of a power shower.
- Insulate the cylinder and the first metres of hot pipe.
- Wash clothes at 30 °C, and use a bowl for washing up.
- Time showers when solar or the engine has heated the water.
9. Frequently asked questions
How can I heat water off-grid?
Common options are a gas instantaneous heater, solar thermal panels, diverting surplus solar PV to an immersion, a wood burner back boiler, or a diesel heater or engine calorifier in vans and boats.
How much energy does it take to heat water?
About 1.16 Wh per litre per °C. Heating 100 L from 10 °C to 60 °C takes about 5.8 kWh.
What temperature should hot water be stored at?
At least 60 °C to control Legionella (HSE guidance), with mixing valves to stop scalding at the taps.
Can I run an immersion heater off-grid?
Only with surplus solar or a generator running anyway. Heating water from batteries uses a lot of stored energy.
10. Sources
- HSE, Legionnaires' disease: hot and cold water systems: hse.gov.uk
- Heat Geek, hot water temperature, scalding and Legionella: heatgeek.com
New to some of the terms? See the glossary. Not sure where to start? Try start here.