Electric hook-up and shore power safety
How hook-up works, site current limits, the right cable, connecting and disconnecting, RCDs, reverse polarity and earth, hook-up abroad, boats and galvanic corrosion, tents, and weak supplies.
By Michael Johnson · Updated 18 November 2026 · How we check our guides
Plugging a caravan, motorhome, boat or tent into a site's electric hook-up (EHU) or a marina's shore power is so routine that it's easy to forget it's a mains connection outdoors, often in the rain, on a supply you know nothing about. A few simple checks prevent tripped breakers, damaged appliances, electric shocks and fires. This guide covers how hook-up works, site current limits, the right cable and how to use it, connecting safely, RCDs, reverse polarity and earth problems, using hook-up abroad, boats and galvanic corrosion, tents and awnings, and making the most of a weak supply.
1. How hook-up works
- UK sites provide a blue industrial socket (to BS EN 60309-2, often called a "16 A blue plug") on a bollard, protected by a breaker and RCD.
- Your caravan or motorhome has its own consumer unit with an RCD and circuit breakers, and usually a mains battery charger.
- Boats connect to marina pedestals in the same way, but with additional corrosion risks (see below).
2. Site current limits
| Site supply | Power available at 230 V | What it runs |
|---|---|---|
| 5–6 A | About 1.2–1.4 kW | Lights, charger, TV, fridge; not a kettle |
| 10 A | About 2.3 kW | A low-power kettle or a heater, but not both |
| 16 A | About 3.7 kW | Most things, one high-power item at a time |
- Check the pitch's limit on arrival. Going over it trips the site's breaker, not yours, and you may need staff to reset it.
- Kettles, heaters, hair dryers, induction hobs and microwaves are the big loads. Microwaves can draw nearly twice their cooking power.
- Use the hook-up calculator to check your loads.
3. The right cable
- Use a purpose-made hook-up lead, typically 25 m with 2.5 mm² cores for 16 A use, with the correct blue connectors.
- Always unwind the cable fully. A coiled cable carrying high current can overheat and melt. Lay excess in loose loops or zig-zags, not a tight coil.
- Don't use household extension reels, splitters, taped joints or domestic plugs.
- Inspect the cable and plugs every time: replace if cracked, scorched, or if the plug pins are discoloured.
- Keep connections off the ground and out of puddles; route the cable where it won't be driven over or tripped on.
4. Connecting and disconnecting safely
- Switch off appliances and your unit's main switch.
- Connect the lead to your caravan, motorhome or boat first.
- Connect the other end to the bollard, and switch on there if it has a switch.
- Switch on your unit's main switch and test the RCD with its test button. It should trip; reset it.
- Check polarity with a plug-in tester if you're unsure of the supply (especially abroad).
- To disconnect, switch off, unplug at the bollard first, then at your unit.
5. RCDs and trips
- The RCD protects against electric shock by cutting the supply when current leaks to earth. Test it every time you connect.
- If it won't trip when tested, don't use the supply; have your system checked.
- Repeated RCD trips can be caused by damp in plugs and appliances, a faulty appliance or a cable fault. Dry things out, unplug appliances one by one to find the culprit, and get faults repaired.
- If a circuit breaker trips, find out why (usually overload) before resetting.
- Have the caravan or motorhome's electrics inspected regularly (often every one to three years).
6. Reverse polarity and earth problems
- Reverse polarity means live and neutral are swapped. Appliances may still work, but switches and fuses can leave parts live when switched off.
- Use a plug-in mains tester in a socket inside your unit to check polarity and earth.
- If polarity is reversed, try another socket on the site. Specialist reversed-polarity adaptor leads exist, but should be clearly labelled and only used when needed.
- Never use a supply with no earth.
7. Hook-up abroad
- Many European sites use the same blue sockets, but in France you may find two-pin-plus-earth sockets, and in some Scandinavian countries and the Netherlands, "Schuko" sockets. Carry adaptor leads made for the purpose.
- Supplies can be lower current (sometimes 6 A or less) and lower voltage, so high-power appliances may not work well.
- Check polarity and earth every time.
- See the travelling abroad guide.
8. Boats and marinas
- Shore power connects your boat's earth to the shore earth, which can create a galvanic circuit with other boats, causing rapid corrosion of underwater metals and anodes.
- A galvanic isolator or an isolation transformer prevents this; most cruising boats on shore power should have one.
- Check anodes regularly.
- Use marine-grade cables and connectors, and keep the lead out of the water.
- See the boat 12 V wiring guide.
9. Tents and awnings
- Use a purpose-made camping mains unit with its own RCD and breaker, raised off the ground.
- Tent hook-up leads are often lighter (1.5 mm², 15 m) and suit lower loads only.
- Keep electrics away from condensation and wet ground; unplug when you go out.
- Don't use heaters or cooking appliances in tents without great care, and never fuel-burning heaters. See the fire and CO safety guide.
10. Making the most of a weak supply
- Use one high-power appliance at a time.
- Use a low-wattage kettle or boil on gas.
- An inverter-charger with an input current limit and power assist can top up from the battery so the site breaker doesn't trip. See the inverter-charger guide.
- Reduce your mains charger's current while other loads are on.
- Solar keeps the battery up when hook-up is limited. See the van solar seasons guide.
11. Frequently asked questions
Why should I unwind my hook-up cable fully?
A coiled cable carrying high current can't cool and can overheat or melt. Always unwind it and lay any excess in loose loops.
How much power does a 10 A hook-up give?
About 2.3 kW at 230 V: enough for one high-power appliance at a time.
What should I do if polarity is reversed?
Try another socket. If that's not possible, use a clearly labelled reversed-polarity adaptor, and never use a supply with no earth.
12. Sources
- The Caravan and Motorhome Club, how caravan electrics work on site: caravanclub.co.uk
- The Camping and Caravanning Club, electricity for campers and caravanners: campingandcaravanningclub.co.uk
- Yachting Monthly, how to prevent an earth loop on your boat: yachtingmonthly.com
New to some of the terms? See the glossary. Not sure where to start? Try start here.