Home › Guides › Lightning and surge protection

Lightning and surge protection for off-grid systems

How lightning damages equipment, when you need protection, earthing and bonding, types of surge protection device, and protecting solar arrays, wind turbines, radio antennas, vans and boats.

By Michael Johnson · Updated 17 November 2026 · How we check our guides

Off-grid homes, sheds and cabins are often the tallest thing around, with long cable runs to solar arrays, wind turbine masts and radio antennas. That makes them vulnerable to lightning: not usually a direct strike, but surges induced in long cables by strikes nearby, which can destroy charge controllers, inverters and radios. This guide covers how lightning damage happens, earthing and bonding, surge protection devices for solar, wind and antennas, and what the standards say.

No system makes you safe outdoors in a thunderstorm. Go inside a building or a hard-topped vehicle. Don't work on masts, antennas or panels when thunder is forecast or heard, and disconnect antenna feeders well before a storm arrives.

1. How lightning damages equipment

2. Do you need protection?

SituationRiskSuggested protection
Van or caravan with roof panelsLowNone special; good fusing and wiring
Shed with a short run to roof panelsLow to moderateBond panel frames; SPD if the controller is expensive
Ground-mounted array with long cablesModerate to highDC SPDs at both ends, bonded frames, earth electrode
Wind turbine on a tall mastHighEarthed mast, SPDs, mast earth bonded to the system earth
Radio antennas and towersHighCoax lightning arrestors at the entry, single-point earth
Exposed hilltop site, high lightning area (much of the US and northern Australia)HighA risk assessment and lightning protection system to BS EN 62305 / NFPA 780 / AS/NZS 1768

3. Earthing and bonding: the foundation

4. Surge protection devices (SPDs)

TypeWhereProtects against
Type 1Main incoming supply, where there's a lightning protection system or overhead linesPartial direct lightning currents
Type 2Consumer unit, inverter AC output, PV DC inputInduced surges (the most common choice)
Type 3Close to sensitive equipmentResidual surges
Coax arrestor (gas discharge tube)Antenna feeder entrySurges on radio cables

5. Solar arrays

6. Wind turbines and masts

7. Radio antennas

8. Vans and boats

9. Frequently asked questions

Do I need lightning protection for my solar panels?

For roof panels with short cables on a van or house, usually just good bonding. For ground-mounted arrays with long cables, or in high-lightning areas, fit DC surge protection at both ends and bond the frames to earth.

What is a surge protection device?

A device that diverts the voltage spike from a nearby lightning strike to earth before it reaches your equipment. Type 2 SPDs are the usual choice for homes and solar systems.

Should I disconnect my antenna in a thunderstorm?

Yes, when storms are forecast. Disconnect the feeder from the radio and earth it. An arrestor reduces damage but disconnection is more reliable. Don't touch antennas once thunder is heard.

Does an earth rod protect against lightning?

On its own, not much. It helps when it's part of a bonded system with surge protection at every cable entry.

10. Sources

  1. ARRL, lightning protection: arrl.org
  2. ARRL, grounding and bonding for the amateur: arrl.org
  3. Electrical Installation Guide (Schneider Electric), SPD for photovoltaic applications: electrical-installation.org
  4. IAEI Magazine, surge protection for photovoltaic systems: iaeimagazine.org

New to some of the terms? See the glossary. Not sure where to start? Try start here.