Home › Electrical basics

LED resistor calculator

Every plain LED needs a resistor to limit its current. In vehicles, size it for the charging voltage, not 12 V.

V
Use 14.4–14.6 V for a 12 V vehicle or leisure system while charging, 28.8 V for 24 V.
V
Red/yellow about 2.0 V, white/blue/green about 3.0–3.3 V.
mA
20 mA for standard 5 mm LEDs; check the datasheet.

Results

Exact resistance—
Nearest standard value (up)—
Power in resistor—
Resistor rating to use—
Current at 12.0 V—

The formula

R = (Supply V − LED Vf × Number of LEDs) ÷ Current (A) Power = Voltage across resistor² ÷ R

Choose the next standard value above the calculated resistance so the current is never higher than intended, and a resistor rated at least twice the power it dissipates.

Why use 14.4 V for "12 V"?

A 12 V vehicle or leisure system sits at 13.5–14.6 V while charging. A resistor sized for exactly 12 V would let the LED run over its rated current whenever the engine, solar or charger is on. Sizing at 14.4 V keeps it safe, at the cost of slightly lower brightness when the battery is resting.

LED strips and lamps

12 V LED strips and replacement bulbs already have resistors or drivers built in. Connect them straight to 12 V. This calculator is for individual LEDs.

Frequently asked questions

What resistor do I need for an LED on 12V?

For a 20 mA white LED (3.2 V) sized at 14.4 V: (14.4 − 3.2) ÷ 0.02 = 560 Ω, a standard value. Use a 1/2 W resistor.

Can I put LEDs in parallel with one resistor?

It's not recommended. LEDs share current unevenly. Give each LED (or each series string) its own resistor.

Related calculators

Calculations and formulas last checked 8 November 2026. Spotted a problem? Tell us.

More in Electrical basics · all calculators